Woods-powr-grip MRTARC811LDC User Manual download pdf (Page 29)

Rev 2.0/7-12 27 MRTA8-DC: #35076RC

REMOTE CONTROL SYSTEM TEST

If the lifter is equipped with a Remote Control System, perform this test in the environment

where the lifter is normally employed. Use the radio transmitter to activate each of the remote

functions.

Vary the location and distance of the transmitter in relation to the lifter, to ensure

that transmissions are effective in a variety of circumstances. This may require assistance from

someone near the lifter, to verify that functions are being performed as intended.

If the Remote Control System does not function correctly, review the following potential causes

of malfunction and correct them as directed:

• The battery for the radio transmitter may be worn out. Replace any expended battery (see

REPLACEMENT PARTS LIST).

• Metal or other electrically conductive surfaces may be causing interference between the radio

transmitter and radio receiver. Although the transmission signals often can bounce around

interfering surfaces, the signals do not travel through conductive walls. Reposition the

transmitter as necessary to transmit signals effectively.

If the preceding directions do not resolve a performance problem, repeat the test under different

conditions, to determine whether there is transmission interference in the work environment or

the Remote Control System is not functioning as intended. Correct any deficiency before

resuming normal use of the Remote Control System. If necessary, contact Wood’s Powr-Grip or

an authorized dealer for assistance.

Use a test material with appropriate surface characteristics (see INTENDED USE: LOAD CHARACTERISTICS) to test the apply and

release functions.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 37 38

No comments

Woods-powr-grip MRTARC811LDC User Manual Page 29