Woods-powr-grip STT1 User Manual download pdf (Page 13)

Rev 8.0/6-12 11 STT1: #35151

TO TRANSPORT THE LOAD ON THE TABLE

Apply the caster brakes and load the table in the folded position (see Figure B), as directed in TO

LOAD THE TABLE preceding. Secure the load onto the table using a strap or other appropriate

means.

WARNING: Make sure load will not cause table to tip over.

A folded table may lack sufficient counter-balance for the load and, if so, could tip over. Support

the load manually until you can verify that the table will not tip over while supporting or

transporting the load. If necessary, place appropriate weight on the table base to stabilize the

loaded table. Release the caster brakes and use 2 people to roll the loaded table to the desired

location; then reapply the caster brakes.

CAUTION: Make sure floor is clean and free from obstructions.

The table casters are designed to be used only on smooth, even surfaces, so make sure to keep

the floor where the table is used clean and free from obstructions.

TO UNLOAD THE TABLE

Before unloading a table, apply the caster brakes. If the table is in the horizontal position, make

sure that the tilt latch is fully engaged. Then remove the load carefully from the table, making

sure to use correct lifting technique.

AFTER USING THE TABLE

Store the table in the folded position (see Figure B), in a dry location.

1 2 ... 8 9 10 11 12 13 14 15 16

No comments

Woods-powr-grip STT1 User Manual Page 13